Filter
Top Products
ENGLISH
• 11 •
4 INSTALLING THE COFFEE
MAKER
For your safety and the safety of third parties,
follow the Safety Standards (see chapter 3).
4.1 Packaging
The original packaging was designed and made
to protect the appliance during shipment. We
recommend you keep it for future needs.
4.2 Preliminaries
• Remove the coffee maker from the packaging
and position it in a suitable location that meets
the requirements specified and described in
the safety standards (chap.3).
• Open the machine door, take the drip tray (12)
from the package, and fit the dump box (10);
then, fit the drip tray in the machine (Fig.21).
• Make sure that the drip tray and grill (Fig.01,
pos. 12), the dump box (10) and the brew
unit (17) are inserted correctly and that the
front door (15) is closed.
• Keep the cleaning brush (20) and the brew
unit key (19) handy as you will need them for
regular maintenance.
If the red light (29) is still on when the
machine is started, it means that one of the
parts described above is positioned
incorrectly.
Caution: You must read chapter 15.
This chapter explains in detail the
meaning of all the visual signals displayed
to the user through the lights (LEDs) found
on the control panel.
4.3 Preparing the coffee maker for use
• Remove the water tank lid (Fig.02) and
remove the tank (Fig.03). Rinse and fill with
fresh water (Fig.04); we recommend that you
do not exceed the MAX level mark. Put the
water tank back in its place and put the lid
on it.
Always fill the tank (9) with fresh still
water. Hot water and other liquids can
damage the tank and/or the appliance. Do
not operate the appliance without water:
make sure that there is enough water inside
the tank.
• Lift the coffee bean container lid (Fig.05) and
fill the container with coffee beans (Fig.06).
Use coffee beans only. Ground and
instant coffee, as well as other items,
cause damage to the appliance.
• Put the lid of the coffee bean container (1)
back in place.
• Insert the plug into the outlet at the back of
the coffee maker (Fig.07) after making sure
that the ON/OFF switch (7) is in the “O”/
OFF position. Insert the other end of the plug
into a suitable wall outlet.
• When not in use, the ON/OFF switch of
the appliance is in the “O” position. To
switch ON the coffee maker, simply press
the switch (Fig.08) to the “I”/ON position.
The LEDs (23) and (24) start flashing on
the control panel.
• To prime the machine, position the steam/hot
water nozzle (Fig.01, item 14) over the drip
tray and place a cup under the steam nozzle.
• Press the hot water button (25) and turn the
steam/hot water knob (16) counterclockwise.
Wait for water to flow regularly from the nozzle
and, then, shut off the flow by turning the knob
clockwise.
Note: You must prime the machine
as soon as it is switched ON for the
first time, if the machine has not been used
for a long time, if the water tank has been
emptied completely or if the warning light
(27) flashes.
• After switching ON the appliance, LEDs (23)
and (24) flash simultaneously during the
heating phase. Once the heating phase is
finished, LEDs (23) and (24) come on steady.
• At this point, your coffee maker is ready for
use. Follow the instructions below to dispense
coffee, hot water or steam and use the
appliance correctly.
Saeco-OEM1-cod 165895900 rev.00-GB-F-S.pmd 02/07/2003, 18.2711