Salton JM1 Juicer User Manual


 
TROUBLESHOOTING
Possible Correction
Try juicing slower, as wet produce is more likely to build up in Cover.
To release pulp, lightly tap on the side of the Cover. Empty Pulp
Basket if full.
Blade Basket may not have been seated correctly, causing it to
become unseated during use. Should this be the case, check the
gear teeth of the Blade Basket and the Motor Base for damage. If any
teeth are damaged, call Consumer Service at (800) 233-9054.
Snug seating is desirable. To insert, try seating the Blade Basket
on a different Hub position. To remove, turn Juice Bowl in a
clockwise direction.
This may be an isolated situation resulting from the varied texture
and moisture content of the produce. Stop juicing, scrape off pulp
and begin again, alternating types of produce.
Pulp may have built up on the Blade Basket. Clean the Blade Basket
and try alternating different types of produce while juicing.
NOTE: Because of the Juiceman’s powerful motor, a small amount of
noise and/or vibration is normal when the Juicer is turned on and
as it comes to a complete stop. All Juicers sound slightly different.
Juice the produce as slowly as possible. Keep the Pulp Basket
emptied for good air flow through machine.
Juice slowly so that the Blade Basket does not full up too quickly
with juice. Keep Pulp Basket emptied to allow good air flow through
the machine.
Juice slowly to avoid excessive pulp buildup inside the Cover and
Juice Bowl.
Symptom
Pulp builds up
excessively in
the back of
the Juicer Cover.
Bottom of
Feed Tube is
damaged.
Blade Basket is
difficult to:
• insert onto
the Hub;
• remove from
the Hub.
Too much pulp
builds up on
Blade Basket.
Excessive noise or
vibrations occur
after Juicer is
turned on.
Juice sprays out
of the Spout.
Juice leaks
between Juice
Bowl and Cover.
Pulp in juice.
12
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit into a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not attempt to
modify the plug in any way.
SHORT CORD INSTRUCTIONS
A short power-supply cord is provided to reduce the risk resulting from
becoming entangled in or tripping over a longer cord.
Do not use an extension cord with this product.
ELECTRIC POWER
If the electrical circuit is overloaded with other appliances, your appliance
may not operate properly. It should be operated on a separate electrical
circuit from other appliances.
3