Filter
Top Products
6
Before Using Your
Express Kettle
Carefully unpack your Express Kettle and remove all packaging
materials. Place your Express Kettle on a level surface such as a
countertop or table.
Thoroughly clean your Kettle before using. Remove Kettle from the
Power Base. Fill the Kettle to its maximum capacity (1.7 litres) with
water and boil. See boiling instructions. When the unit shuts off,
discard the water. Rinse the Kettle out with cold water. Wait ten
minutes to allow the heating element to cool. Repeat this process
two more times.
Boiling Instructions
1. Place Power Base on a level surface such as a countertop or
table. The Power Base must be dry before use.
2. Raise the ON/OFF Lever into the OFF position. (See Figure 2).
3. Remove Kettle from the Power Base.
4. Open the Lid by pressing the Lid Release Buttons together
and lifting up. (See Figure 3).
Fill the Kettle with the desired
amount of water. Close the
Lid and wipe excess water off
the Kettle.
NOTE: If the Lid is not prop-
erly closed, the Kettle will not
atuimatically shut off.
OFF
FIGURE 2
FIGURE 3
MEK17W-395 2 7/2/03 10:47 AM Page 6