Filter
Top Products
5. Place the Kettle on the Power Base, engaging the connector
into the bottom of the Kettle. Be careful not to spill any water
onto the Power Base.
6. Plug the Power Base into 120V ~ 60 Hz electrical outlet.
7. Press the ON/OFF Lever down, into the ON position, the
Indicator Light will come on.
8. When the water comes to a boil the Kettle will automatically
shut off and the Indicator Light will turn off.
NOTE: The Kettle can be turned off at any time during the
heating process by using the ON/OFF Lever.
9. Remove the Kettle from the Power Base before pouring.
NOTE: Always wait until the Kettle is off before removing it
from the Power Base.
10. To reheat water, place Kettle back onto Power Base and press
ON/OFF Lever down, into the ON position. Be careful not to
spill any water onto the Power Base.
11. Unplug the Power Base when not in use. Allow it to cool
before reuse.
Cleaning Your
Express Kettle
CAUTION: Do not immerse Kettle or Power Base in any liquid,
or place in a dishwasher to be cleaned.
1.
Raise the ON/OFF Lever into the OFF position and unplug
unit. Allow unit to cool before cleaning.
2. Open the Lid by pressing the Lid Release Buttons together
and lifting up (Revert back to Figure 3).
3. Remove the Scale Filter from inside the Kettle by pressing
down on tab on the front of the filter inside of spout. (See
Figure 4a). Pull up and
out from the Lid
Opening. (See Figure
4b). Rinse under run-
ning water and use a
soft brush if necessary
(do not use a metal
brush). Replace Scale
Filter.
7
FIGURE 4a FIGURE 4b
MEK17W-395 2 7/2/03 10:47 AM Page 7