Filter
Top Products
5. When desired browning is complete, either remove browned
food and continue with the recipe, or add recipe ingredients to
the Pressure Cooker Pan and begin pressure cooking according
to recipe instructions.
6. When finished, turn the Variable Temperature/Pressure Control
to WARMING and unplug the unit. The POWER Indicator Light will
turn off.
STEAMING
This Function quickly brings cooking liquid to a boil for steaming
fresh vegetables or rice. Times will be similar to cooking the same
food on top of the stove in a sauce pan.
1. Position the electrical cord in the slot located on the bottom of
the Pressure Cooker.
2. To steam food, place food in the bottom of the Pressure Cooker
Pan or you may use a small heat-resistant steaming rack or
basket (not included) in the bottom of the Pressure Cooker Pan.
Add at least 1 cup of water when cooking up to 30 minutes. Do
not fill the Pressure Cooking Pan past the MAX Fill Line, 2/3 full.
3. Add the Lid and lock it into place onto the Pressure Cooker Pan
following the instructions in the For Your
Safety section of this manual.
4. On the top of the Lid, turn the Pressure
Regulator Valve to STEAM.
5. Turn the Variable Temperature/Pressure
Control to WARMING. Plug the unit into a
120V AC wall outlet. The POWER
Indicator Light will illuminate.
NOTE: The Lid can be removed while
STEAMING to check the food for
doneness, but you must wait for the
Pressure Lift Pin drops.
6. Turn the Variable Temperature/Pressure
Control to STEAM, 3 to 5 (see illustration).
The Pressure Lift Pin may raise and lower
during cooking as the unit cycles on and
off to maintain the temperature.
7. When steaming is completed, turn the Variable
Temperature/Pressure Control to WARMING and unplug the unit.
The POWER Indicator Light will turn off.
8. Wait until the Pressure Lift Pin drops and remove the Lid.
WARNING: Use caution when lifting Locking Lid. Escaping steam can
scald you, and the Lid will be hot.
10
F e a t u re s
VARIABLE TEMPERATURE/PRESSURE CONTROL
Your Pressure Cooker has variable temperature control that cycles
on and off to maintain the temperature. Adjust the setting as
necessary.
WARMING
This Function reheats or keeps cooked
food warm. WARMING can either be used
on its own or after pressure cooking to
keep food warm.
1. Position the electrical cord in the slot
located on the bottom of the Pressure Cooker.
2. Place or leave cooked food in Pressure Cooker Pan.
3. Turn the Variable Temperature/Pressure Control to WARMING.
Plug the unit into a 120V AC wall outlet. The POWER Indicator
Light will illuminate.
4. If you would like to keep food warm after steaming or pressure
cooking, after cooking is completed and pressure has been
released, simply turn the Variable Temperature/Pressure Control
to WARMING, 1, 2, or 3. Stir frequently.
5. When finished, turn the Variable Temperature/Pressure Control to
WARMING and unplug the unit. The POWER Indicator Light will
turn off.
BROWNING
Braised foods always taste better when
browned before cooking in liquid. The Russell
Hobbs® Electric Pressure Cooker has a built-
in browning cycle.
1. Position the electrical cord in the slot located on the bottom of
the Pressure Cooker.
2. For best results, food should be patted dry with paper
towels and cut into small, uniform pieces. Brown or sauté
food using a small amount of oil in small batches.
3. Add the appropriate amount of oil as called for in the recipe to
the Pre s s u r e Cooker Pan. With the Lid off, plug the unit into a
120V AC wall outlet. The POWER Indicator Light will illuminate. Tu rn
the Variable Te m p e r a t u re / P re s s u re Control to MAX/BROWNING,
7, 8, or 9.
4. After approximately 5 minutes of preheating, add food and
begin browning without the Lid.
WARNING: Do not leave the Pressure Cooker unattended while
browning foods.
9
F e a t u res ( C o n t i n u e d )