Filter
Top Products
02 SURFACE COOKING
Surface cooking _19
Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as shown below.
6
1 5 2
4
3
1. Single element: Left rear
2. Single element: Right rear
3. Dual element: Left front
4. Dual element: Right front
5. Warming center: Center rear
6. Hot surface indicator
Hot surface indicator
Comes on when the unit is turned on or hot to the touch.•
Stays on even after the unit is turned off.•
Glows until the unit is cooled to approximately 150°F.•
Cooking areas
The cooking areas on your range are identified by permanent circles on the glass cooking •
surface. For the most efficient cooking, fit the pan size to the element size.
Pans should not extend more than ½” to 1” beyond the cooking area.•
When a control is turned on, a glow can be seen through the glass cooking surface. • The
element will cycle on and off to maintain the preset heat setting, even at high settings.
For more information on selecting proper types of cookware, refer to the section “Using the •
proper cookware” on page 22.
FE-R500_XAC DG68-00295A.indb 19 2010-02-18 �� 11:33:14