Filter
Top Products
18_ Setting Up
4. Remove the fi lter cap and insert the fi lter into the fi lter
housing.
5. Slowly turn the water fi lter 90º clockwise to align with the
printing mark on the cover, locking the fi lter in position.
Make sure to align the water fi lter label mark with center of
cover fi lter printing as illustrated. Remember, do not over-
tighten.
You should remove the right side upper glass shelf before installing water fi lters.
Removing any residual matter inside the water
supply line after installing the water fi lter.
1. Turn ON the main water supply & turn OFF the valve to
the water supply line.
2. Run water through the dispenser until the water runs clear
(approx. 6-7 minutes). This will clean the water supply
system and remove air from the lines.
3. Additional fl ushing may be required in some households.
4. Open the Refrigerator door and make sure there are no
water leaks coming from the water fi lter.
Be sure to fl ush the dispenser thoroughly or water may drip from the dispenser.
This is due to the fact that there is still air in the line.
Check the amount of water supplied to the ice tray.
1. When you press the TEST button, the ice cube container is fi lled with water from the water supply
tap. Check to make sure the amount of water is correct (see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem of the
main water pipes, not the Refrigerator. If this problem occurs, contact the dealer service center
for help.
Setting up your French Door Refrigerator
Turn until the label
aligned.
Separation
of red cap.
Cover fi lter.
4 5
Feeler Arm
Test button
Check the water level
/NE4OUCH0URE7ATER