Filter
Top Products
Operating _25
02 OPERATING
Using the water dispenser
Place a glass underneath the water outlet and push gently against the water dispenser lever with your glass.
Make sure the glass is in line with the dispenser to prevent the water from splashing out.
If you have just installed the Refrigerator or just installed a new water filter, pour out the first six glassfuls of water to
flush out impurities in the water supply system. Make sure water flows cleanly before drinking.
Using the ice off Function
When selecting the Ice Off mode, remove all ice cubes from the bucket. If you are not using
the ice dispenser, the ice cubes may clump together. Pull the lock lever forward to throw
away ice cubes or remove clumped ice from the bucket. Push the bucket back until you
hear a click.
If you use all the ice at once, steps 3 and above 4 must be repeated (before dispensing
the first 4 to 6 ice cubes, you need to wait 8 hours). This will replenish the ice cubes
and ensure maximum ice production.
All water provided to refrigerators flows through the core filter which is an alkaline water filter. In this process, the
pressure in the water that has flowed out of the filter gets increased, and oxygen and nitrogen become saturated.
When this water flows out in the air, the pressure plummets and the oxygen and nitrogen get supersaturated,
which results in gas bubbles. The water may temporarily look misty or cloudy due to these oxygen bubbles. After
a few seconds, the water will look clear.
Please wait 1 second before removing the cup after dispensing water to prevent spills. Do not pull out the lever
dispenser after taking out ice or water. It comes back automatically. Ice is made in cubes. When you select
“Crushed”, the ice maker grinds the ice cubes into crushed ice.
• In case ice doesn’t come out, pull out the ice bucket and press the test button
located on the right side of ice maker.
• Do not press the test button continuously when the tray is lled with ice or water.
Water may overflow or ice jamming may occur.
• Normal Use
To fill the ice bucket to maximum capacity after installation, make sure to do the
following steps.
1. Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
2. Waiting 24 hours will allow your ice maker to cool properly.
3. Dispense 4 to 6 ice cubes into the glass.
4. After 8 and 16 hours, dispense a full glass of ice.
When you dump the ice from the ice bucket, you should press the dispenser lever
once with ‘ICE CUBED’ or ‘CRUSHED’ function ON to get new ice faster after replacing the ice bucket in the
refrigerator.
When you do not use the water dispenser for 2~3 days (especially during the summer), the dispensed water
may have a funny smell or taste.
If this occurs, we recommend that you discard the first 1~2 glasses for better tasting water.
Use only the ice maker provided with the refrigerator. The water supply to this refrigerator must only be
installed/connected by a suitably qualified person and connect to a potable water supply only. In order to
operate the ice maker properly, water pressure of 138 ~ 862Kpa is required. If you have a long vacation or
business trip and won’t use water or ice dispensers, close the water valve.
- Otherwise, water leakage may occur.
Wipe excess moisture from inside and leave the doors open.
- Otherwise, odor and mold may develop.
Use running water to clean the ice tray bucket, do not use detergent or your hands. Do not put your fingers or
any other object in the chutes or blades, as it may result in injury or damage to the refrigerator.
Never put your finger or any other objects in the dispenser opening.
- It may cause injury.
Do not try to disassemble the ice maker. Do not wash or spray the ice bucket with water.
CAUTION
CAUTION
CAUTION
CAUTION
Test button
Check the
water level