Filter
Top Products
setting up _13
01 SETTING UP
RE-ASSEMBLING THE FLEX
DOOR
To reattach the flex doors, assemble parts in
reverse order.
Be sure to connect the Flex Door Wire
Connector.
If it is not connected, the Flex Room does
not work.
DISASSEMBLING THE
FREEZER DOOR
1. Take out the upper drawer by lifting it up.
2. Remove the freeze room guard ( 1 ) by lifting
the guard up.
3. Take out the lower
basket ( 2 ) by lifting
the basket up from
the rail system.
4. Press the fixing
hook of the rail
system.
5. Holding the top of the Freezer Drawer, pull it
out all the way, and then remove it from the rail
system.
CAUTION
Be careful not to scratch or dent the
sliding rail by letting it strike the floor.
Make sure that you mount the freezer
basket in the right position when removing
/ installing the freezer door. Failing to do
so may result in the door not opening or
closing properly.
Putting too much food into the freezer
drawers can prevent the freezer from
closing completely and can cause frost
build-up.
RE-ASSEMBLING THE
FREEZER DOOR
To reattach the drawer after you have moved
the fridge to its fi nal location, assemble the parts
in reverse order.
ADJUSTING THE LEVEL
Make sure the refrigerator is level so that you can
make final adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, you will not
be able to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
CAUTION
CAUTION
CAUTION
1
2
DA68-02894A-09.indb 13DA68-02894A-09.indb 13 2013. 12. 3. 8:452013. 12. 3. 8:45