12_ operating
( 5 ) Fridge
(Hold 3
sec for
Power
Cool)
Touch this button to set the fridge to your
desired temperature.
You can set the temperature between 34°F
and 46°F (or between 7°C and 1°C).
Touch and hold this button for 3 seconds to
decrease the time needed to cool products
in the Refrigerator. It can be helpful if you
need to quickly cool easily spoiled items or
if the temperature in the fridge has warmed
dramatically
(For example, if the door was left open).
( 6 ) Ice Off
(Hold 3
sec for
child lock)
If you don’t want to make more ice, touch
this button. Also, pressing this button for 3
seconds locks the display panel and
dispenser buttons so the buttons can not
be used.The Child Lock icon lights up to
indicate you’ve activated the Child Lock
function. Press 3 seconds to unlock.
(7) Ice Type
Touch this button to select your desired
ice type. Cubed and crushed ice modes
alternate when you press the button. This
mode can not be used with the Water mode
simultaneously.
(8) Water
Touch this button to dispense water. This
mode can not be used with the Ice Type
mode simultaneously.
Water mode will be off if you Touch the Ice
Type button.
Cooling Off
Mode
Cooling Off mode (also called Shop mode),
is designed for use by retailers when they
are displaying refrigerators on the shop
floor. In Cooling Off mode, the refrigerator's
fan motor and lights work normally, but the
compressors do not run, and the refrigerator
and freezer do not get cold.
To start Cooling Off mode, touch and hold
the Energy Saver button and the Power
Freeze button for 5 seconds during normal
operation. The refrigerator chime sounds and
the temperature display flashes OF OF.
To cancel Cooling Off mode, touch and hold
the Energy Saver and the Power Freeze
buttons again for 5 seconds.
( 1 ) Energy
Saver
Touching this button turns Energy Saver
mode on and off. When you turn Energy
Saver on, the Energy Saver icon lights.Turn
Energy Saver off and the icon goes off.
The Energy Saver function automatically
turns on when power is supplied to the
refrigerator.
If condensation or water drops appear on
the doors, turn the Energy Saver mode off.
( 2 ) Freezer
(Hold 3
sec for
Power
Freeze)
Touch this button to set the Freezer to your
desired temperature.
You can set the temperature between -8°F
and 8°F (or between -22°C and -14°C).
Touch and hold this button for 3 seconds to
decrease the time needed to freeze products
in the Freezer. It can be helpful if you need
to quickly freeze easily spoiled items or if
the temperature in the Freezer has warmed
dramatically (For example, if the door was
left open).
Power Freeze turns off automatically after
72hours to decrease energy consumption.
When you use this function the energy
consumption of the refrigerator will increase.
Remember to turn it off when you don’t
need it and return the freezer to your original
temperature setting. If you need to freeze
large amount of food stuff, activate Power
Freeze function at least 24 hours before.
( 3 ) Alarm /
Hold 3
sec for
Filter
Reset
This button serves two purposes:
1) To turn the door open alarm on and off
If the door alarm is set to On, an alarm beeps
if any refrigerator door is left open for more
than three minutes.
The beeping stops when you close the
door. The door alarm function is pre-set
to On in the factory. You can turn it off by
touching and then releasing this button. You
can turn it back on in the same fashion. The
icon lights up when the function is on.
2) To reset the water filter life indicator.
After you replace the water filter, touch and
hold this button to reset the water filter life
indicator.
( 4 ) Lighting/
Hold 3
sec for
C↔F
Touching this button turns on the Dispenser
LED lamp (under the display) in continuous
mode so that it stays on continuously.
The button also lights up. If you want the
Dispenser lamp to come on only when some
one uses the dispenser, press the Lighting
button to turn the continuous mode off.
Touch and hold this button for 3 seconds
to switch the temperature units between °C
and °F
DA68-02481A-10.indb 12 13. 4. 25. �� 2:18