Filter
Top Products
16_ Operating
If a power failure occurs, ice cubes may melt
then freeze together when the power comes
back on, causing the dispenser to be out of
order.
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
After you dump the ice from the ice bucket,
you should press the dispenser lever once
with the ‘ICE
CUBED’ or
‘CRUSHED’
function ON.
The ice maker will
make new ice faster
after you return the
ice bucket to the freezer.
If you use all the ice at once, you must
repeat Steps 2 and 3 on the previous
page. However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes. This
will replenish the ice cubes and ensure
maximum ice production.
Using the ice off Function
When you select
the Ice Off mode,
remove all ice
cubes from the
bucket. If you are
not using the ice
dispenser, the ice cubes may clump together.
Pull the lock lever forward to remove the bucket.
Throw away the ice cubes or clumped ice. Push
the bucket back until you hear a click.
Use only the ice maker provided with
the refrigerator. The water supply to this
refrigerator must only be installed/connected
by a suitably qualified person. Connect to a
potable water supply only.
To operate the ice maker properly, water pressure
of 20 ~ 125 psi is required.
If you have a long vacation or business trip and
won’t use the water or ice dispensers for a long
time:
- Close the water valve. Otherwise, water
leakage may occur.
- Remove all food.
- Unplug the refrigerator.
- Wipe excess moisture from inside and leave
the doors open. Otherwise, odor and mold
may develop.
Do not put your fingers, hands or any other
unsuitable objects in the chute or ice-maker
bucket.
- It may result in personal injury or material
damage.
Never put your finger or any other objects in the
dispenser opening.
- It may cause injury.
Do not try to disassemble the ice maker.
Do not wash or spray the ice bucket with water
while it is in the refrigerator. Remove it to clean it.
When you insert the Ice maker tray, be sure
that the tray is well centered at the entrance.
Otherwise, the tray may be stuck.
Water clouding phenomenon
All water provided to the refrigerator flows
through the core filter which is an alkaline water
filter. In the filtering process, the pressure of
the water that has flowed out of the filter is
increased, and the water becomes saturated
with oxygen and nitrogen. When this water flows
out into the air, the pressure plummets and
the oxygen and nitrogen get supersaturated,
which results in gas bubbles. The water may
temporarily look misty or cloudy due to these
oxygen bubbles. After a few seconds, the water
will look clear.
Please wait 1 second before removing the cup
after dispensing water to prevent spills. Do not
pull out the lever dispenser after dispensing ice
or water. It comes back automatically. Ice is
made in cubes. When you select “Crushed”, the
ice maker grinds the ice cubes into crushed ice.
CAUTION
CAUTION
CAUTION
CAUTION
PULL PUSH
DA68-02481A-10.indb 16 13. 4. 25. �� 2:18