Filter
Top Products
16_ operating
- The temperature of the Freezer, fridge or
Convertible Room may rise when you open
the doors too frequently, or if a large amount
of warm or hot food is placed inside.
- This may cause the digital display to blink. Once
the Freezer and fridge temperature return to their
normal set temperatures, the blinking will stop.
- If the blinking continues, you may need to “reset”
the Refrigerator. Try unplugging the appliance, wait
for around 10 minutes and then plug the power
cord back in.
- If there is an communication error between the
Display and Main Controller, the Convertible
Display light may blink. Once the normal set
temperatures are reached, the blinking will stop.
If the blinking continues for a long period of time,
please contact a Samsung Electronics Service
Center.
USING THE TWO LEVER DISPENSER
Push the appropriate ice type button to
select what you want dispensed.
Using the ice lever ( 1 )
Push the Ice lever dispenser ( 1 )
gently with your glass. Ice will be
released from the dispenser.
You can choose the type of ice by
pushing the cubed or crushed button
fi rst.
Using the Water lever ( 2 )
Push the Water lever dispenser ( 2 ) gently with your
glass. Water will be released from the dispenser.
Even if you push the water and Ice lever
simultaneously, the dispenser operates only
the option you selected or pushed fi rst.
Using the Ice & Water Dispenser together
To get Ice and water, push the Ice lever ( 1 ) fi rst for
ice, then move your glass down and press the water
dispenser lever ( 2 ) for water.
Do not pull the lever out. You could damage
or break the lever's spring.
• To clean the ice bin/bucket, wash with
a mild detergent, rinse well, and dry
thoroughly it. Do not use harsh or abrasive
cleaners or solvents.
• When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
• In case ice doesn’t come out, pull out the ice
bucket and press the test button located on the
right side of ice maker.
• Do not press the test button continuously when
the tray is fi lled with ice or water. Water may
overfl ow or ice may jam the bucket.
• Normal Use
To fi ll the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and cool down
for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to cool
properly.
2. Dispense 4 to 6 ice cubes into the glass.
3. After 8, and then 16 hours, dispense a full glass of
ice.
Recommend Temp (Fridge) : 38F
Recommend Temp (Fridge) : 38F
NO ICE
NO ICE
Select this if you want to
Select this if you want to
turn ice maker off
turn ice maker off
1
2
check the
check the
water level
water level
Test button
Test button
CAUTION
CAUTION