Filter
Top Products
01 SETTING UP
5. Position the top table (
2
) in place. Insert the 3
screws into the top table, and tighten with a philips
screw driver (+). Open the door, reinsert the cap top
table (
1
) and close the doors.
REATTACHING THE REFRIGERATOR DOORS
When reattaching the top table, make sure that the
wires are not pressed or damaged by the hinge cover.
After assembling, close the door and check to see
whether the door has gaps between gaskets or is
tilted. If they are, please refer to “Adjusting the level” on
page 15.
1
2
3
3
7
4
5
4. Connect the water line (
5
) and then insert a clip
on the coupler with pulling tube. Connect the one
connector (
4
) on left side door, the other connector
(
7
) on right side door and two connectors (
3
) at
each side of the top cap.
The clip is enveloped inside of the top cap.
Setting Up _13
DA68-01926A-10.indb 13 13. 4. 24. �� 11:37