Filter
Top Products
SAFETY NOTES
Please referto product's modeland No. whilecontrasting each other;
Before power supply connected, please make sure the matching between refrigeratory's voltage
range and supplied voltage. The optional voltage range is from 220V to 240V; if power supply not
meeting the requirement, then the auto-transformer with minimum 500 W output power should be used.
In case of power supply shutdown, wait for 5 minutes or longer interval for running again lest compressor
damaged.
Do not place food near temperature sensor lest negative effects to correct display of temperature sensor;
In hot seasons, avoid to keep door open long time or to open and closefrequently, otherwise the
efficiency of total set shall be weakened, and the running load shall also be increased.
Keep in mind and do not reverse or make it lie down. If necessary to makeit incline,the gradient between
cabinet and ground should be less than 45 degree;
Do not move it by holding door handle; or to pull or draw the door handle forcibly;
If abundant hot items placed in at one time, keeping it open long time oropening frequently, the cabinet
temperature shall be increased, and temperature display also flashes. usually it shall recover within 24
hours.
PRE-RUNNING ISSUES
1. Remove all package material and remove
bottom pad before running.
2. Make the interior and external clean with mild wet cloth
( little natural cleaner can be added to mild water).
3. Keep it ready and after 1 hour, plug in the power supply.
Please refer to the upper indication and conduct relative
operations.
The appliance must be installed so that the plug is easily accessible .
Keep ventilation openings, in the appliance enclosure or in the build-in structure, clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
Do not damage the refrigerant circuit.
Do not use electrical appliances inside the food storage compartments of the appliance, unless they
are of the type recommended by the manufacturer.
DISMOUNT METHOD OF ATTACHMENT
Attachment application
Fruit Box Cover
Toraise up the rearportion, then takeit out.
Cabinet Lamp Replacement
Draw out the plug of power supply
To loose the screw behind the lamp cover. And take out
lamp cover by means of unclenching along its edge with
flat screw-driver.
To screw out the bulb anti-clockwise.
To screw in new bulb clockwise.
To embed lamp cover again and fix the screw behind
lamp cover.
Lighting lamp specification: 220/240V, 20W ,E14
Lift the shelf head and pull it out. (Position the
shelf as per the container height)
Refrigerator shelf
Freezer tray
Draw out it till the block, lift the shelf rear and
pull it out.
Egg guard and bottle guard
Lift them up to take them down.
In case of heavy food stuff preserved in the drawer,
hold drawer up slightly and pull it back.
4
13
WARNING
NOTES