Filter
Top Products
24
CHECKING THE WATER DISPENSER LINE
1) In order to operate the ice maker properly, water pressure of 20~125 psi(0.138~0.862 Mpa) is
required. In this range, a 6 oz paper cup can be filled in 10 secs.
2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.
3) If the refrigerator is installed in area with low water pressure (below 20psi), you should install a boost-
er pump to compensate for the low pressure.
4) Ensure the water storage tank inside the refrigerator is filled. Push the water dispenser
lever until the water runs from the outlet.
- Shut off the main water supply line and turn the
Ice maker to the off position.
- Locate the nearest cold water line.
- Follow the instructions in the ice maker
installation kit.
- After connecting the water supply with water
filter, turn on water supply and flush 4 or more
gallons into a bucket to clear the water filter.
1. Cold Water line.
2. Pipe Clamp.
3. Water Line Installation Kit.
4. Shut Off Valve.
NOTE
Water line installation kit is available at extra cost from your dealer. The refrigerator
manufacturer recommends using a water supply kit containing copper tubing.
Connecting to water supply line
DA68-01606A-0.0 9/2/06 10:48 AM Page 24