Filter
Top Products
26
INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
Install the water filter.
1) Turn on the main water supply & shut-off valve of the water
supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
2) If the water filter was installed in March, put on the "SEP" sticker.
3) Remove the Red protective cap from the filter, then position and insert the filter as shown.
4) Slowly turn the water filter as shown below to align the indication mark on the cover, locking the filter in
position. Do not overtighten.
WATER
ICE
• A newly-installed water filter cartridge may cause water to briefly
spurt from the dispenser.
NOTE
• Please check that the indication line aligns with the lock position.
NOTE
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
COVER FILTER
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
1) Remove the fixed cap (A) as shown. the fixed cap separates from the Water Filter Compartment by
rotating it as shown.
Remove the water filter from the box and put a month
indicator stick on the filter as shown.
Keep the cap(A) in a safe place for recapping, when you
don’t need to use the filter.
NOTE
The water filter is located in the extra space behind the Deli Bin.
NOTE
(A)
DA68-01606A-0.0 9/2/06 10:48 AM Page 26