Filter
Top Products
29
Function & How- to-use By Products
APP .EX)TO DECREASE FREEZER STANDARD TEMP BY (-5.4°F/-3°C).
Option Setting
(6:(-5.4°F/-3°C))
Option CATE.
(0:Freezer Standard Temp)
1-3) If you set "10"as shown in the Freezer option table below after setting "1"to the OPTION CATEGORY,the
Refrigerator standard temp will be lowered by -5.4°F(Refer to the Refrigerator Temp Option Table)
:In 20 seconds after completion of adjustment,the MICOM will store the set value to the EEPROM and
it will revert to the normal display and the option setting mode will be cancelled.
1-4)To increase/decrease the OPTION CATE., press the Fridge button and the Filter Reset(or Lighting
button)respectively and to increase/decrease the OPTION SET VALUE, press the Freezer button and the
Ice Type button respectively.
1-5)The option function will be set in the EEPROM before shipment,so do not change the setting except
special cases.For the option function, the setting will be completed when it is reverted to the normal
display in 20 seconds. So, do not turn off the power before it is reverted to the normal display.
1-6) Make sure to set the OPTION CATE.(I1~I5)first and then set the OPTION SETTING(V1~V4).
Note) Basically,refrigerators are shipped with option data cleared.
i.e.products are shipped with set values all "0".But,for quality improvements during MP,refrigerators could
be produced with set values changed.So,make sure to check the Quality Information.
Value- Value+
V1 V2 V3 V4
Item+
I1 I2 I3 I4 I5
Item-
Option Setting
(6:(-5.4°F/-3°C))
Option CATE.
(0:Freezer Standard Temp)
Value- Value+
V1 V2 V3 V4
Item+
I1 I2 I3 I4 I5
Item-
RS2630SW/XAA (for Best Buy)
RS2531
**
/RS2631
**