Filter
Top Products
setting up _9
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
If not, first check the power supply and electricity source or try the troubleshooting section at the back of
this user’s guide. If you have any further questions, contact your Samsung Electronics service center.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessory list below.
01 SETTING UP
First things first! Make sure that you can easily move your refrigerator to its final location by measuring
doorways (both width and height), thresholds, ceilings, stairways, etc.
The following chart details the exact height and depth.
MODEL
RSG25**
Dimensions(inch)
Width
Only Cabinet
35 3/4
With Leg Front
35 15/16
Depth
Only Cabinet
23 5/8
With Door
27 7/16
With Handle
30
Height
Only Cabinet
68 5/8
With Hinge
69 5/16
With Door
70
• Allow clearance to the right, left, back and top when installing. This will help reduce power
consumption and keep your energy bills lower.
• Do not install the refrigerator where the temperature can drop below 50°F (10°C).
• Make sure you disconnect the water supply line BEFORE removing the freezer door. See the
next section on “Separating the Water Line” to avoid damage.
Water filter
(DA29-00003B)
Hex wrench
(DA80-00002C)
Compression fitting
(DA62-00305A)
Compression nut
(DA74-00070B)
Clip
(DA61-04521A)
Clip
(DA61-04522A)
Screw
(6001-000541)
DA99-01746A(EN)-GGH-0.2.indd 9 2008.11.10 3:32:4 PM