Filter
Top Products
14
CLEANING THE WATER DISPENSER
Connection path
Wipe over the connection path and surrounding area with a clean
damp cloth.
Cup Support / Dispenser Tray
Cup support/Dispenser tray
Press “PUSH” behind the dispenser tray slightly, then
remove the dispenser tray.
Using the cup support handle, pull the cup support right
out.
Empty the water in the dispenser tray, then clean it
using warm water and detergent.
Dispenser tray
Cup support
Water Tank / Supply Device
Pull upward and disassemble the hooks on both
sides of the large-sized cap.
Loosen the water supply device by turning it in the
direction of the arrow and removing it.
Wipe the large-sized cap and the exclusive water tank
with warm water and detergent.
• Hold the cap and pull it upwards to remove it. Clean the
cap and waste filtering bottle attached to the cap with a
soft brush.
After cleaning the water supply device with a soft
brush, press the water supply device operation lever,
then wash it in running water.
• Clean the water tank frequently if it is used to dispense tea or other such beverages. Only use
filtered tea. For better hygiene, beverages with a high sugar content (juice, soft drinks) are not
recommended.
• Deposits can be cleaned by wiping the tank with a cloth dampened in vinegar or salt water.
• Check that the rubber seal on the water supply device has not slipped off or is not damaged
by a sharp-edged object. Otherwise, it may leak.
Caution
W2-PJT(EN) 12/8/01 11:24 AM Page 14