Sanyo ECJ-S35S Rice Cooker User Manual


 
11
Check the current time.
1
After selecting a MENU, press the TIMER button.
2
Press the HRS and MIN buttons to set the time of completion.
3
Press the COOK/START button.
4
HOW TO USE TIMER COOKING
(Rice cooking completes at a specific time.)
Initial Setting:
When the timer
is set for 6:00am.
Clock time is correct.
Example: 12:00 noon
Lamp
changes from
flashing to lit.
AFTER TIMER COOKING STARTS
If you want to change the timer setting:
If you want to check the current time:
The current time will be displayed
while holding HRS and MIN buttons.
SETTING TIMER
Timer must be set for the minimum times listed below. Otherwise, cooking will start immediately.
Menu White, Rinse-Free, Sprouted Brown
1 hour and 10 minutes
Quick Rice
1 hour
Brown Rice
1 hour and 40 minutes
Porridge
1 hour and 10 minutes
Time Required
TIMER COOKING
Set the timer after preparing the rice following steps (1)-(3) in the How
to Cook Rice section.
Check the current time. If the clock has not been set to the correct time,
timer cooking may not work properly. ( page 8)
The timer cannot be set if the KEEP WARM lamp is lit or flashing.
Press KEEP WARM/OFF button to turn off the lamp.
Press HRS button to change the hour. The hours change in
1-hour increments. Press MIN button to change minutes. The
minutes change in 10-minute increments.
The timer can be fast-forwarded by holding down the HRS or
MIN buttons.
The time displayed for 12:00 noon is “0:00 PM”
The TIMER lamp will change from flashing to lit and the
appointment time will be shown on the DISPLAY PANEL.
This completes the timer setting.
The TIMER lamp will go off when cooking starts and the
COOK lamp will light.
Timer cooking should be set to begin within 12 hours.
The rice may begin to deteriorate if the rice is left in the
water for an extended time.
Do not use timer cooking to prepare mixed rice, bi bim bab
or sweet rice that contains other ingredients. These
ingredients or seasonings may deteriorate or settle to the
bottom and fail to cook properly.
Rice may turn out soft when cooked using the timer.
Once the timer has been set, timer cooking can be
performed in two steps.
• Press TIMER button after reviewing the menu selection.
Press COOK/START button after reviewing the time setting.
• Previous timer settings are stored in memory.
The TIMER lamp will begin flashing and the timer setting
will be shown on the DISPLAY PANEL.
If the existing timer setting is correct, then proceed to the
operation described in section 4.
page 9 for menu selection.
Press the KEEP WARM/OFF button, and
then reset the timer following steps
(2)-(4) described before.