Filter
Top Products
21
TROUBLE SHOOTING
If the unit malfunctions, check out the following before calling for service.
The chamber is not cooled at all
1. The circuit breaker of power source is active.
2. The voltage is too low. (In this case, call an electrician.)
3. The power switch is not ON.
4. The large amount of articles (load) is stored in the chamber at one time.
5. The freezer is in defrost condition.
The cooling is poor
1. The ambient temperature is too high.
2. The door is not closed firmly.
3. The large amount of frost is built on the chamber wall.
4. The air intake vent is blocked.
5. The set temperature is not inputted properly.
6. The freezer is in the direct sunlight.
7. There is any heating source near the freezer.
8. A rubber cap and insulation for the access port are not set correctly.
9. You put too many unfrozen articles into the freezer compartment.
When the unit does not accept changes of set-point temperature
1. The key lock is set in “ON” mode.
Noise
1. The freezer is not installed on the sturdy floor.
2. The freezer is not leveled with the leveling feet.
3. There is anything touching the frame.
4. The freezer is in the status immediately after start up.
The unit sometimes causes a noise when the chamber temperature is high due to the large load. The
noise gets less and less accompanying with the cooling of the chamber.
DISPOSAL OF UNIT
WARNING
If the unit is to be stored unused in an unsupervised area for an extended period ensure that children
do not have access and doors cannot be closed completely.
The disposal of the unit should be accomplished by appropriate personnel. Always remove
doors to prevent accidents such as suffocation.