Filter
Top Products
11InRow RC Operation and Maintenance Manual
Password entry
The cooling unit has two levels of password protection:
• Device password allows Device Users to change basic and environmental settings.
• Admin password allows all privileges granted for Device Users, and also allows the Administrator to
modify settings that control the components in the cooling unit or change advanced options.
When you try to change a setting, the display interface prompts you to enter your Admin password. The default
value for both the Device and Admin password is apc (lowercase). To enter your password, use the up or down
arrow key to scroll through the available character set. Press the ENTER key to select the current character
and move the cursor to the next character position. After selecting the last character of your password, press
the ENTER key once more to submit your password.
Once the password is entered, it remains in effect until the period of inactivity exceeds the Password Timeout
setting.
See “Password & timeout” on page 21.
NOTE: Passwords are case sensitive.
Start the cooling unit
Path: Main > On/Standby
1. To start the cooling unit, press the ENTER key until the cursor is on the Operation > On/Standby menu
item.
2. Press the ENTER key again to show the toggle state arrow to the right of Operation.
3. Use the up and down arrow keys to change from Standby to On.
See “Path: Main > Operation > Limit Access” below if you are prompted to enter a password
before changing the On/Standby setting.
4. Press the ENTER key again to set the On position.
a. The fans will start.
b. The cooling unit will run according to the configured settings.
NOTE: On/Standby only affects the local cooling unit. You must set the On/Standby option for each
cooling unit in the cooling group.
Path: Main > Operation > Limit Access
The default setting for the Limit Access password protection option is No. If the Limit Access option has been
set to Yes, you will be prompted to enter the Device password before a change can be made to the On/
Standby setting.