Filter
Top Products
Electrical
The machine is not supplied with a power cord, one
must either be field installed or the machine
hard-wired.
The dataplate on the back of the cabinet details the
power requirements, including voltage, phase,
minimum circuit ampacity and maximum fuse size.
HACR type circuit breakers may be used in place
of fuses. Extension cords are not permitted. Use of
a licensed electrician is recommended.
The ice maker is designed to operate on its own
electrical circuit and must be individually fused.
Voltage variation must not exceed the limits listed
earlier.
The remote condenser is designed to be powered
from the ice machine. A separate knockout hole
has been provided in the ice maker electrical
junction box.
Electrical connections are made inside the junction
box in the back panel of the ice machine.
1. Remove the junction box cover and route the
power cord through the access hole and
properly attach the power supply wires to the
leads in the junction box.
2. Attach the remote condenser fan motor wires
to the wires in the junction box tagged “fan
motor leads”.
3. Install field supplied strain reliefs per code.
Attach a ground wire to the ground connection
in the junction box.
4. Check voltage when complete.
5. Return the junction box cover to its original
position and secure with the original screws.
Follow all applicable local, state and national
codes.
July 2006
Page 14
C0522 through C1030
Remote Condenser Models - User Manual
To Re m ote
Condenser
Fan Motor
Junction
Box
Cover
Power
Supply
Wires
Ground
Wire
Connection
Install
Strain
Relief
Install
Strain
Relief
Electrical Connection Detail