Filter
Top Products
The Self-Clean Cycle
(some models)
BEFORE A CLEAN CYCLE
1o
Remove the broil pan and grid, oven racks, all utensils
and any foil that may be in the oven. Do not tryto clean
utensils or any other objects in the oven during a self-
clean cycle. If oven racks are left In the range during
a clean cycle, they will darken, lose their luster and
become hard to slide. Ifyou choose to leave the racks
inthe oven, you can polish the edges of the racks with
steel wool and apply a small amount of vegetable oilto
the rack edges after the self-clean cycle. This will make
the racks easier to slide.
2° Soil on the oven front frame, under the front edge of the
cooktop (does not apply to built-in ovens), the door liner
outside the door seal and the front edge of the oven
cavity (about 1" into the oven) will not be cleaned during
a clean cycle (see illustration). Clean these areas by
hand before starting a clean cycle.
Use hot water with a soap-filled steel wool pad, then
rinse well.
.
4.
Wipe up heavy spillovers on the oven bottom. Too much
soil may cause smoking during the clean cycle.
Clean the door seal by using a clean sponge to soakthe
soiled area with hydrogen peroxide. Repeated soaking
may be needed depending on the amount of soil. Frequent
cleaning will help prevent excessive soil buildup. Do not
rub the door seal. The fiberglass material of the seal has
an extremely low resistance to abrasion. An intact and
well fitting oven door seal is essential for energy efficient
oven operation and good baking results. If you notice the
seal becoming worn, frayed or damaged in any way or
if it has become displaced on the door, you should
replace the seal.
FRONT FRAME
/
DOOI
DOOR UNER
AFTER A CLEAN CYCLE
After a clean cycle, you may notice some white ash in the
oven. Just wipe it up with a damp cloth.
If white spots remain, remove them with a soap-filled steel
wool pad. Be sure to rinse thoroughly with a vinegar and
water mixture. These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, the cycle may
need to be repeated.
19 GSCL01-6