Filter
Top Products
7oif tapeholdsbottomdrawer cover to drawer supports,
remove the tape Pull drawer partway out. Reach in,
push the rear of the glass up and, at the same time, back,
until it clears front-corner retainers,
8, Tilt and remove the cover
9. Tilt and remove the drawer
After cleaning, replace
drawers and covers in
reverse order Reinstall the
gasket at the rear of the top
drawer. Fit the end of the
plastic drawer support into
the slot on the gasket, with
the rubber gasket flap facing
you Make sure the gasket
snaps into place
Drain Opening in Freezer Compartment
When cleaning, remove
the freezer bin and flush
a solution of baking soda
(one teaspoon) and two
cups of hot [not boiling)
water through the drain
fine with the help of a
meat baster This will
help eliminate odor and
reduce the likelihood of a clogged drain line
If drain becomes dogged, use a meat baster and
baking-soda-and_water solution to force the clog through
the drain line,
Condenser
The condenser is located
behind the base grille, For
most efficient operation,
remove the base grille
and sweep away or vacuum
up dust that [sreadily
accessible For best results,
use a brush special}y
designed for this purpose. It is available at your Sears
store or service center. This easy cleaning operation
should be done at least once a year
Behind Refrigerator
Take care moving your refrigerator away from the wall
All types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces
Pull the refrigerator slraight out and return it to position by
pushing it straight in Moving refrigerator in a side direction
may damage floor covering or refrigerator
Light Bulb Replacement
Unplug the refrigerator before changing a llght bulb,
Fresh Food Compartment--Upper Light
!. Pull off temperature control knobs
Pin
2. Pull the bottom of the light shield down and forward,
then rotate the top up and off
3o After replacing with same size bulb, reinstall light
shiefd
Fresh Food Compartment--Lower Light (on some
models)
This light is Iocated behind a shield atthe rear of
the _:reshbad compartment
1. Grasp the top edge of the shield and llft it up
and forward to Freeits top edge
2. After replacing with same size bulb, hook the top
of the shield back in place
Freezer Compartment
1_Remove she}f iust below
light panel (Shelf will be
easier to remove if it is
emptied first )
2. Pull plastic light panel
toward you, (It will bend to
free tabs from grooves,)
3, After replacing with same size bulb, reinstall panel
and shelf.
13