Filter
Top Products
PLANNING YOUR INSTALLATION
When planning your installation, use the drawings be-
low and on page 5 to guide you, There are many van-
ables to consider' as you plan, Some of these are:
t,," The water filter' housing inlet and outlet internal
threads are 318" NP'E
existing plumbing type (copper; threaded, etc.) and
nominal size (114", 318" etc.)
tools you have, and your plumbing skills
t.," cost of materials needed
t.* space available fbr installing the filter' housing
Sears has optiona! kits available to make installing the
water' filter housing easier' (see below and page 5)
These are:
_k Installation Kit, Sears Stock No. 42-34386 - Includes
318" fittings and tubing
Installation Kit, Sears Stock No. 42-34387 - Includes
3f8" fittings and tubing, water' supply saddle valve,
and a separate faucet for filtered water'.
-k Mounting Bracket, Seat's Stock No, 42-34388 - (in-
cluded with deluxe model)
Make a simple sketch of your' proposed installation,
and a list of plumbing materials you will need Obtain
evep/d_ing you need before starting the installation.
Be sure you have the tools required.
TYPICAL UNDERSINK INSTALLATIONS / TOOLS AND MATERIALS NEEDED
INSTALLATION ON COPPER PLUMBING USING COMPRESSION FITTINGS
\ SINK / compression / --
elbow / "_
f
I
/
HOT / apply several
shutoff valve / wraps of
Note: Tochange the / Teflontiape
filter cartridge, you
mustturnoffthewa-
ter. A nearby shutoff t
valve is convienenL /
Most sinks already/
have shutoff valves/
on the supply pipe& 1
INLET
3/8" NPT
Note: Be sure to allow a minimum
space of 1-1t2" under the filter for
removing the sump, to change the
cartridge.
! _ Mounting Bracket -includes screws
Sears Stock No.,42-_34388
j (included with Deluxer_odel)
/
nut
brass
ferrule
compression
adaptor (use elbow
or straight fitting)
- MATERIALS AND TOOLS NEEDED -
2 compression adaptors (either straight fit-
tings as shown, or'elbows), 3/8" NPT x comp..
ii_ 2 compression elbows, 3/8" NPT x comp.
(compression end to fit existing pipe)
Note: Sears has an installation kit available
that fits 3/8" O.D. pipe size, Stock No.
42-34386.
Teflon tape
tubing cutter
_- sandpaper or emery-cloth
_9wrenches, either nn_n_t_._.,end n,_.._=,4ju_t=bI,=_..
jaw, size to fit compression adaptors
4