Sears 75376 Range User Manual


 
Care and Cleaning ( oo oood)
Broiler Pan and Grid
After broiling, remove the
broiler pan from the oven
or broiler compartment
(depending on your model)_
Remove the grid from the
pan° Carefillly pour out
grease from the pan into a
proper container. Wash and
! !
! -- !
: ,,,,,7_i_
rinse the broiler pan and grid in hot water with a
soap-filled or plastic scouring pad.
If food has burned on, sprinkle the grid with detergent
while hot and cover with wet paper towels or a dishcloth.
Soaking the pan will remove burned-on foods.
Both the broiler pan and grid can also be cleaned in a
dishwasher.
Do not store a soiled broiler pan and grid anywhere
in the range.
CAUTION: Do not clean the broiler pan or grid in
a seff-deaning oven.
Oven Shelves
Clean the shelves with an abrasive cleanser or steel
wool. After cleaning, rinse the shelves with clean water
and dry with a clean cloth.
NOTE: Take the shelves out of the oven before you
begin the seLiLclean cycle.
Oven Bottom
The oven bottom has a
porcelain enamel finish.
To make cleaning easier,
protect the oven bottom
from excessive spillovers by
placing a cookie sheet on
the shelf below tile shelf
you are cooking on. You
can use aluminum foil if
you do not cover the whole shelf. This is particularly
important when baking a fruit pie or other foods with
a high acid content. Hot fruit fillings or other foods
that are highly acidic (such as tomatoes, sauerkraut and
sauces with vinegar or lemon juice) may cause pitting
and damage to the porcelain enamel surface and
should be wiped lip immediately.
To clean up spillovers, use soap and water, an abrasive
cleaner or soap-filled steel wool pad° Rinse well to
remove any soap before self-cleaning.
30
Surface Light and Starter
(on some models)
CAUTION: Do not
touch the bulb with wet
hands or when bulb is
hot. Never wipe the
fight area with a wet
cloth. Electrical power
must be shut off ff you
have to replace a bulb.
, Lift up
Starter
To replace the starter:
1. Open the canopy and remove the bulb as
explained above_
2. Grasp the starter, turn it counterclockwise about
one-quarter turn and lift out. Replace with one of
the same wattage_
3. Replace the bulb and lower the canopy.
To replace the bulb:
1, With one hand at each Light bulb
end of the hinged
canopy, grasp it by the
front edge and flip it up.
2. Remove the fluorescent light bulb. Replace the bulb
with one of the same length and wattage.
3. Lower the canopy.