Sears 911.91468 Range User Manual


 
"DOIT YOURSELF"TEMPERATUREADJUSTMENT
You may feel that your new oven cooks
differently than the oven it replaced. We
recommend that you use your new oven a few
weeks to become more familiar with it,
following the times given in your recipes as a
guide.
ff you think your new oven is too hot (burning
foods) or not hot enough (foods are
undercooked) you can adjust the temperature
yourself. Theappearanceandtextureoffoods
is a better indicator of oven accuracy than an
inexpensive thermometer, such as those found
in grocery stores, to check the temperature
settingofyournewoven. Thesethermometers
can vary by 20-40 degrees. In addition, the
oven door must be opened to read these
thermometers. Opening the door will chat?ge
the temperature of the oven.
To decide how much to change the
temperature, set the oven temperature 25
degrees higher (if foods are undercooked) or
25 degrees lower (if foods are burning) than
the temperature in your recipe, then bake. The
results of this "test" should give you an idea of
how much the temperature should be changed.
1
2.
Turn to OFFand remove theknob by pulling
straight off
Look at the back of the knob. The arrow
pointing to the center of the bottom screw
indicates the original factory setting.
3. Use a scre wdriver to loosen the two screws
about2 turns each.
4. Hold the knob handle (A on illustration) while
turning the disk (B on illustration) inthe desired
direction to increase or decrease the
temperature. (See illustration below for
"Standard Thermostat. ") As you turn, you
should be able tohear clicks and feel notches
or tee th. Each click or notch is 15_F. You can
tum up to 2clicks or notches in either direction.
5. When you reach the desired adjustment,
retighten both screws. Return the knob to the
range.
(See illustration below--use the
arrows in the gray area to make your
temperature adjustment.)
"A .... B"
KNOB
DISK
TOMAKEOVEN
COOLER
TURN DISK
TOMAKEOVEN
HOTTER
TURNDISK
ARROW .._
20