Filter
Top Products
EN-5
MAINTENANCE MODE
Should any of maintenance indicators appear in the display, follow the instruction:
CC Mode Reason Action required
CC1
CC2
Operation time of magnetrons exceeds
1,250 hours.
Call for service to replace the parts promptly. Failure to
replace parts that have exceeded recommended operation
time may cause failure of the microwave oven.
CC4 Operation time of the control unit, relays,
switches exceeds 200,000 times.
CC3 Operation time of exhaust motor exceeds
3,000 hours.
Even though CC3 is displayed, your oven can still be
operated for short periods of time. Call for service to
replace parts promptly.
NOTES:
1. The CC and “ * “ indicator will appear in the display when recommended parts life is exceeded. The CC and “ * “
indicator can be cleared by pressing the STOP/CLEAR pad. Call for service to replace the parts promptly. Failure to
replace parts that have exceeded recommended operation time may cause failure of the microwave oven.
2. If one maintenance mode or more than one maintenance mode occurs at the same time, the display will show CC
and the numbers of the modes separated by a period. For example, if CC1 occurs, the display will show CC and 1
reciprocally or if CC2 and CC4 occur at the same time, the display will show CC and 2.4. reciprocally.
GROUNDING INSTRUCTIONS
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire
with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance
with the National Electrical Code and local codes and ordinances.
WARNING – Improper use of the grounding plug can result in a risk of electric shock. The electrical requirements
are 120 Volt, 60 Hz, AC only, and 20 Amp or more (R-CD1200M); 230/208 Volt, 60 Hz, AC only, and 15 Amp or more
(R-CD1800M); 230/208 Volt, 60 Hz, AC only, and 20 Amp or more (R-CD2200M) fused electrical supply. It is recommended
that a separate circuit serving only this appliance be provided. When installing this appliance, observe all applicable
codes and ordinances. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade
grounding plug and a 3-slot receptacle that will accept the plug on the appliance. The marked rating of the extension
cord should be AC120 Volt 20 Amp (R-CD1200M), AC230/208 Volt 15 Amp (R-CD1800M), AC230/208 Volt 20 Amp
(R-CD2200M). Consult a qualifi ed electrician or serviceman if the grounding instructions are not completely understood
or if doubt exists as to whether the appliance is properly grounded.
Plug Confi guration
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven
is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and
signal of receiving antenna.
Receptacle Box Cover
3-Pronged plug
(NEMA 6-20P)
3-Pronged Receptacle
(NEMA 6-20R)
230V/208V 20A
R-CD2200M
Receptacle Box Cover
3-Pronged plug
(NEMA 5-20P)
3-Pronged Receptacle
(NEMA 5-20R)
120V 20A
R-CD1200M
Receptacle Box Cover
3-Pronged plug
(NEMA 6-15P)
3-Pronged Receptacle
(NEMA 6-15R)
230V/208V 15A
R-CD1800M