Filter
Top Products
18
Customer Service Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Using the probe.
(on some models)
For many foods, especially roasts and poultry, internal food temperature is the best test for doneness. The
temperature probe takes the guesswork out of roasting by cooking foods to the exact doneness you want.
Use of probes other than the one
provided with this product may result in
damage to the probe.
Use the handles of the probe and plug
when inserting and removing them from
the food and outlet.
■
To avoid damaging your probe, do not use
tongs to pull on the cable when removing it.
■
To avoid breaking the probe, make sure food is
completely defrosted before inserting.
■
To prevent possible burns, do not unplug the
probe from the outlet until the oven has
cooled.
■
Never leave your probe inside the oven during
a self-cleaning cycle.
■
Do not store the probe in the oven.
The temperature probe has a
skewer-like probe at one end and a
plug at the other end that goes into
the outlet in the oven.
After preparing the meat and placing it
on a trivet or on the broiler pan grid,
follow these directions for proper probe
placement.
Insert the probe completely into the
meat. It should not touch the bone,
fat or gristle.
For roasts with no bone, insert the probe
into the meatiest part of the roast. For
bone-in ham or lamb, insert the probe
into the center of the lowest large muscle.
Insert the probe into the center of dishes
such as meat loaf or casseroles.
Insert the probe into the meatiest part of
the inner thigh from below and parallel
to the leg of a whole turkey.
How to Set the Oven For Roasting When Using the Probe
(on some models)
Insert the probe into the food.
Plug the probe into the outlet in the
oven. Make sure it’s pushed all the
way in. Close the oven door. Make
sure the probe cable is not touching
the broil element.
Touch the
PROBE
pad.
Touch the number pads to set the
desired internal food or meat
temperature.
Touch the
BAKE
pad.
Touch the number pads to set the
desired oven temperature.
Touch the
START
pad.
The display will flash if the probe is inserted into
the outlet and you have not set a probe
temperature and touched the START pad.
After the internal temperature of the
food reaches 100°F., the changing
internal temperature will be shown in
the display.
When the internal temperature of
the food reaches the number you
have set, the probe and the oven
turn off and the oven control signals.
To stop the signal, touch the
CLEAR/OFF
pad. Use hot pads to
remove the probe from the food.
Do not use tongs to pull on it—they
might damage it.
To change the oven temperature during
the Roast cycle, touch the
BAKE
pad and
then the number pads to set the new
temperature.
■
If the probe is removed from the food before
the final temperature is reached, a tone will
sound and the display will flash until the probe
is removed from the oven.
■
You can use the timer even though you
cannot use timed oven operations while
using the probe.
Plug
Probe
Cable
Handles