Filter
Top Products
3
INSTALLATION INSTRUCTIONS
ACCESSORIES
Check to make sure the following accessory is provided:
• Operation manual
• Caution Sheet (SPECIAL INSTRUCTIONS AND WARNINGS : part code TCAUHA429WRRZ,
TCAUHA430WRRZ and TCAUHA445WRRZ)
NOTE:
• When you order accessories, please mention the two items : part name and model name to your dealer or
SHARP authorized service agent.
• The model name is printed on the door of the microwave oven.
WARNING : Always keep the caution sheet (SPECIAL INSTRUCTIONS AND WARNINGS) close to the oven
for your reference.
25 cm
6-5)Hold the mounting plate A to the rear cabinet of the
oven A with the single screw (a), as shown in the
figure A.
6-6)Remove the screw (a) holding the mounting plate B
to the rear cabinet of the oven B. And remove the
mounting plate B from the oven B. See the figure A.
6-7)Install the screw (a) to its position again.
6-8)Remove the screw (c) from the oven A.
6-9)Remove the screw (d) from the oven B.
6-10)Turn the removed mounting plat B over and then
using the removed screw (c) and (d), attach the
mounting plate B, as shown in the figure A.
WARNING:
In case where two ovens are installed together by
placing one on top of another.
1) Use the two mounting plates for fixing the two
ovens.
2) Make sure that the power supply cord is not caught
between the two ovens.
3) Do not install more than one oven on top of another.
4) Do not lose the removed screws.
1) Remove all packing materials from the inside of
the oven cavity. Remove all the blue protective
film from the outside of the oven.
2) Check the oven carefully for any signs of damage.
3) Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked.
Do not place this oven in a position which is not
easily accessible. To position the oven too high
can be dangerous because food can not be re-
moved safely.
4) Ensure there is a minimum free space above the
oven of 25 cm.
5) Securely connect the plug of the oven to a standard
earthed (grounded) household electrical outlet.
6)
Two same oven models can be installed together by
placing one on top of another. Follow these instructions.
6-1)Place the oven A and position the oven B on top of
the oven A as shown in the figure A.
6-2)Remove the single screw (a) holding the mounting
plate A to the rear cabinet of the oven A. And
remove the mounting plate A.
6-3)Remove the single screw (b) from the rear cabinet
of the oven B, as shown in the figure A.
6-4)Reinstall the mounting plate A to the rear cabinet
of the oven B with the single screw (b) removed,
as shown in the figure A.
Screw (a)
Screw
Mounting Plate A
Screw (b)
Screw (a)
Oven B
Screw (c)
Rear cabinet
Mounting Plate B
Oven A
(d)
Rear cabinet
Figure A: How to fix two ovens
NOTE
1. If you are unsure how to connect your oven, please
consult an authorized qualified electrician.
2. Neither the manufacuture nor the dealer can accept
any liability for damage to the oven or personal
injury resulting from failure to observe the correct
electrical connection procedure.
3. Water vapour or drops may occasionally form on the
oven walls or around the door seals and sealing
surfaces. This is a normal occurrence and is not an
indication of microwave leakage or a malfunction.
SEEG R22/23/25.En1-14 13.7.10, 6:21 PM3