Filter
Top Products
20
Disconnect the power cord before cleaning or leave the door open to inactivate the oven during cleaning.
Exterior
The outside surface is painted. Clean the outside with
mild soap and water; rinse and dry with a soft cloth. Do
not use any type of household or abrasive cleaner.
Door
Wipe the window on both sides with a damp cloth to
remove any spills or spatters. Metal parts will be easier
to maintain if wiped frequently with a damp cloth.
Cleaners which are marked specifi cally for use with
stainless steel may be used for stainless steel model.
Follow package directions exactly. Avoid the use of any
harsh cleaners or one not marked for stainless steel use
as they may stain, streak or dull the door surface.
Touch Control Panel
Care should be taken in cleaning the touch control panel.
If the control panel becomes soiled, open the oven door
before cleaning. Wipe the panel with a cloth dampened
slightly with water only. Dry with a soft cloth. Do not
scrub or use any sort of chemical cleaners. Close door
and touch STOP/CLEAR.
Interior
Cleaning is easy because little heat is generated to
the interior surfaces; therefore, there is no baking and
setting of spills or spattering. To clean the interior
surfaces, wipe with a soft cloth and warm water. DO
NOT USE ABRASIVE OR HARSH CLEANERS OR
SCOURING PADS. For heavier soil, use baking soda
or a mild soap; rinse thoroughly with hot water.
NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO
ANY PART OF THE OVEN.
Waveguide Cover
The waveguide cover, located on the right side wall,
is made from mica so requires special care. Keep
the waveguide cover clean to assure good oven per-
formance. Carefully wipe with a damp cloth any food
spatters from the surface of the cover immediately
after they occur. Built-up splashes may overheat and
cause smoke or possibly catch fi re. Do not remove the
waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the oven.
To remove, combine 1 cup water, grated peel and juice
of 1 lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100%
power. Allow to set in oven until cool. Wipe interior with
a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and non abrasive
scouring sponge. They are also dishwasher-proof. Use
upper rack of dishwasher. The turntable motor shaft is
not sealed, so excess water or spills should be wiped
up immediately.
CLEANING AND CARE
402J 403K 405K manual_418.indd 20402J 403K 405K manual_418.indd 20 16.03.2006 11:49:20 Uhr16.03.2006 11:49:20 Uhr