Sharp R-90GC Microwave Oven User Manual


 
11
A37159,SEC R90GC O/M
TINSEA986WRRZ-D31 SEC R90GC
SPEED COOKING
Your oven has 3 special speed cooking modes.
Caution:
The oven cabinet, cavity, door, turntable, turntable sup-
port, rack and dishes will become hot. To PREVENT
BURNS, use thick oven gloves when removing the food
or turntable.
1.GRILL
Use the GRILL setting for steaks, chops, chicken pieces
and many other foods you would normally grill that are
not included in Basic Cook on pages 16-18. GRILL is a
preprogrammed setting that cooks fast with a high tem-
perature and maximum speed hot air circulation. Only
actual cooking time is entered; the oven signals when
it is preheated to 450°F. The oven temperature cannot
changed.
Suppose you want to grill a steak for 15 minutes.
* If the oven door is not opened, the oven will auto-
matically hold at the preheat temperature for 30 min-
utes. After this time has elapsed, an audible signal
will sound and the oven will turn off.
NOTE:
1.
You can grill foods without preheat.To program grill with-
out preheat, touch GRILL twice at step 1.
2. Foods cook quickly using GRILL. Check often to en-
sure desired results.
3. Either the high or low rack may be used. The high
rack grills food the fastest. Place the splash guard on
the turntable with either of the racks over it.
PROCEDURE
1
Touch GRILL.
3
Touch START.
Preheat starts.
No food in oven.
4
Open the door. Place food in the oven.
Close the door.
Touch START.
2
Enter cooking time.
When the oven reaches the programmed
temperature, a signal will sound 4 times*.
Before operating your new oven make sure you read
and understand this operation manual completely.
Before the oven can be used, follow these
procedures:
1. Plug in the oven. Close the door. The oven display
will show SHARP SIMPLY THE BEST PRESS
CLEAR AND PRESS CLOCK.
2. Touch the STOP/CLEAR pad.
will appear.
3. Set clock. See below.
4. Follow directions on page 30 for using the Refresh
Cycle.
BEFORE OPERATING
:
TO SET THE CLOCK
Suppose you want to enter the correct time of day
12:30.
This is a 12 hour clock. If you attempt to enter an
incorrect clock time, ERROR will appear in the display.
Touch the STOP/CLEAR pad and re-set the clock.
If the electrical power supply to your oven should be
interrupted, the display will intermittently show
SHARP SIMPLY THE BEST PRESS CLEAR AND
PRESS CLOCK after the power is reinstated. If this
occurs during cooking, the program will be erased.
The time of day will also be erased. Simply touch
STOP/CLEAR and reset the clock for the correct time
of day.
STOP/CLEAR
Touch the STOP/CLEAR to:
1. Erase if you make a mistake during programming.
2. Cancel timer.
3. Stop the oven temporarily during cooking.
4. Return the time of day to the display.
5. Cancel a program during cooking, touch twice.
PROCEDURE
Touch CLOCK and
number pad 2 .
1
2
Enter the correct time
of day by touching the
numbers in sequence.
3
Touch CLOCK again.
MANUAL COOKING