Filter
Top Products
710.0026 R1.2 SmarTire LF Initiator Operating Instructions
4
Learn: Press this button to make a sensor transmit a ‘Learn’ transmission. Learn transmissions are
used when reprogramming sensor ID numbers into the SmarTire receiver.
LED FUNCTIONS
Whenever a button is pressed, the LF Initiator Tool indicates its status by the color of its LED light.
• GREEN
= Working properly (approx 5 second illumination duration)
• RED
= Not working properly (contact SmarTire distributor for replacement)
• ORANGE
= Low battery voltage
GETTING STARTED
The SmarTire LF Initiator is powered by a standard 9 Volt battery. To install the battery, open the
battery access panel on the back of the tool and connect the supplied battery to the 9 Volt battery
connector. Insert the battery into the slot and close the battery access panel. Push the ON / OFF
switch up to power the tool on and down to power it off.
USING THE LF INITIATOR
The SmarTire LF Initiator Tool is very easy to use. Simply hold it approximately 1 inch (2.5 cm)
away from the tire’s surface positioned at the center of the tire’s sidewall at the location of the valve
(SmarTire sensors should be installed at the valve and their location should also be indicated by a
rim mounted label). Press (but do not hold down) the button and hold the tool in place for
approximately 5 seconds to ensure the wireless signals emitted from the tool reach the sensor.
REFERENCE ONLY