Smeg 142468 Refrigerator User Manual


 
142468
29
Fault: Cause/Remedy
The appliance does not
operate after connection to
the mains:
Check if there is power in the socket and if the
appliance is switched on.
Cooling system operates
continuously without
intermittent stoppages:
Ambient temperature too high.
Frequent opening of the door, door open too long.
Door not closed properly (particle between door
gasket, sagged door, check gasket sealing, etc...).
Excessive quantity of fresh food inserted at once.
• Refrigerator sensor (A) is crammed with fresh food.
Free the sensor and allow air to circulate around it.
Check air circulation for suf cient cooling of the
compressor, and clean the condenser.
Excessive ice formation at
the rear interior wall of the
refrigerator:
Frequent opening of the door, door open too long.
Inserting hot food in the refrigerator.
Food or dish is touching the rear interior panel of the
refrigerator.
Bad door sealing; clean or replace the gasket if dirty
or damaged.
Water dripping from the
appliance:
Drain outlet is clogged, drain water drips past the
collection groove.
Clean the clogged outlet using plastic straw.
Thaw thick ice deposits manually (see chapter
Defrosting).
Red light is ashing (freezer
compartment only):
Frequent opening of the door, door open too long.
Door not closed properly (particle between door
gasket, sagged door, damaged gasket, etc...).
Excessively long power failure.
Excessive quantity of fresh food inserted at once.
Troubleshooting guide