Filter
Top Products
Instructions for the installer
42
2. INSTALLATION OF THE APPLIANCE
It is the law that all gas appliances are installed by competent persons.
Corgi gas installers are approved to work to safe and satisfactory
standards. All gas installation, servicing and repair work must be in
accordance with the gas safety regulations 1984 (installation and use) as
amended 1990.
It can be placed against walls higher than the hob, at a distance of at
least 50 mm from the side of the appliance, as shown in the drawings A
and B relating to the installation classes. Wall units or extractor hoods
located above the hob must be at least 750 mm away from it.
A B
SLOT IN FREE STANDING
2.1 Positioning and levelling of the appliance
This appliance is fitted with 4 castors for easy positioning. To block the
appliance in tis final position, extract the feet on the front and screw the
corresponding castors in.
CAUTION: delicate floors could be damaged by the castors; in this case,
lift the appliance with a mechanical means.
2.2 Electrical connection
Make sure that the power line voltage matches the specifications
indicated on the rating plate located inside the storage compartment.
This rating plate must never be removed.
The connection to the mains shall be done conforming to the regulations
in force. Check that the power line is adequately grounded. Do not use
reducers, adapters or shunts. On the power line, install an omnipolar cut-
off device with contact cut-off distance greater than or equal to 3mm,
located in an easily accessible position near the unit.