Filter
Top Products
Instructions for the installer
2. INSTALLATION OF THE APPLIANCE
This unit is equipped with a type Y fire protection, and may be set
against walls that are higher than the hob.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
2.1 Levelling
Adjust the four feet so as to set the appliance on a perfectly level plane.
For this purpose, loosen the lock nut and unscrew the foot. The range of
adjustment of the screw is 10 mm.
2.2 Electrical connection
Make sure that the power line voltage matches the specifications
indicated on the rating plate located inside the storage compartment.
This rating plate must never be removed.
On the power line, install an omnipolar cut-off device with contact cut-off
distance greater than or equal to 3 mm, located in an easily accessible
position near the unit.
The appliance is fitted with
a terminal board at the rear
for electrical connections
(see following diagram). To
access, remove the rear
cover
32