Filter
Top Products
Instructions for the installer
32
The diagrams illustrate the cutting sizes and additional shaping required for the installation hole if you
decide to install the hob flush with the work-top surface. The work-top hole and shaping dimensions
are purely guideline; it is essential to refer to your actual ceramic hob before making any cuts.
After you have attached the adhesive strip supplied with the hob to the underside of the glass (A)
position the hob precisely and centrally in the cut out, and mount it with the mounting brackets. Fill any
small gaps between the top of the worktop and the underside of the hob with silicone (B) to create a
waterproof seal. Take care to clean any excess silicone from the surfaces before it sets. If it is
necessary to remove the hob, cut the silicone with a small sharp blade (C) before trying to remove it.