Filter
Top Products
User instructions
32
TABLE FOR CERTIFICATION BODIES
Reference standard EN 50242
Reference program
(*) Selector on
3
Load 12 place-settings
Type of detergent B
Amount of detergent 30 g
Rinse aid setting Depending on the model 3/4 or 4/6
EN 50242
3.2 Washing programs
Before starting a washing program make sure that:
•
The water supply tap is
open.
•
The
correct amount of detergent
has been added to the
dispenser
.
•
The baskets have been
correctly loaded.
•
The spray arms are able to
rotate freely
and without obstruction.
•
The dishwasher door is
securely closed
.
CANCELLING THE CURRENT PROGRAM
To cancel the program in progress the dishwasher must be switched off by pressing the
ON/OFF
key
(3)
(see section "3. Description of the controls").
Turn the program selector to
SOAK
and wait for the dishwasher to start. On completion of the
program, switch off the dishwasher by pressing the
ON/OFF
key
(3)
.
CHANGING THE PROGRAM
To change the program in progress the dishwasher must be switched off by pressing the
ON/OFF
key
(3)
(see section "3. Description of the controls").
Turn the program selector to the program required and then switch the dishwasher on again by
pressing
ON/OFF
key
(3)
. The dishwasher will carry out the new program automatically.
PROGRAM DELAY
The start of the washing program can be delayed by
from 1 to 12 hours
. This allows you to
operate the dishwasher at the time of day most convenient to you.
Using the
DELAYED START
switch
(7)
(see section "3. Description of the controls") set the “delay”
required by setting the pointer against the number indicating the hours. Then carry out the usual
program setting procedures.
CAUTION: always turn the switch clockwise.