Smeg CH500 Freezer User Manual


 
11
GB
Fault nding
Fault Possible cause Remedy
No light in display. There is not enough light for the solar
sensor.
Turn on the light.
No control lamps are
lit.
The appliance is switched off.
Power failure; the fuse is blown; the
appliance is not plugged in correctly.
Check the plug and socket.
Check that power is connected.
Reset the fuse.
Temperature in freezer
too high.
The ventilation grille is blocked.
The lid is not closed properly.
The quantity of fresh items placed
in the freezer is greater than the
capacity of the appliance.
Thick layer of frost and ice.
The thermostat is set too high.
Ensure unhindered air circulation.
Close the lid and wait a few hours.
Wait a few hours.
Defrost the freezer.
Set the thermostat to a lower
temperature.
Temperature in freezer
too low.
Super Freeze is activated.
The thermostat is set too low.
The lid is touching items stored in the
freezer.
Switch Super Freeze off.
Set the thermostat to a higher
temperature.
Reposition items inside the freezer
and check that the lid closes tightly.
The freezer produces
large quantities of frost.
Air humidity in the room is high.
Items placed in the freezer are giving
off moisture.
Ventilate the room more often or
move the freezer to a room with lower
humidity.
Repack items stored in the freezer.
The lid cannot be
opened.
There is underpressure in freezer. Wait 2-3 minutes until the
underpressure has been equalised
and try again.
Vibration and unusual
noise.
The appliance is not on a level
surface.
The appliance is not free standing.
Baskets or partition are loose.
Position the freezer on a at, level
and stable surface.
Move the appliance away from other
appliances or pieces of furniture.
Check movable ttings and reposition
them.