Filter
Top Products
Instructions for the Installer
38
2. INSTALLING THE APPLIANCE
This appliance has fire protection (type Y) and can be installed against
walls higher than the work surface.
In compliance with Electromagnetic Compatibility regulations, the
electromagnetic induction hob is classified in Group 2 and Class B (EN
55011)
2.1 Electrical connection
Check that the voltage and size of the power supply line are as specified
on the nameplate inside the storage compartment. This nameplate
must never be removed.
The appliance's power supply line must be fitted with an omnipolar
breaking device with contact gap of at least 3 mm, located in an easily
accessible position close to the appliance itself.
The appliance has a terminal board on its rear for the electrical
connection (see diagram below). To access it, remove the back cover.