Filter
Top Products
User instructions
31
DISABLING THE ACOUSTIC DEVICE AND ADJUSTING THE FILLING SYSTEM
The dishwasher’s electronic control system allows you to:
•
Disable the acoustic device which confirms all dishwasher programming and operating steps;
•
Adapt the dishwasher’s water filling system to the mains water pressure.
Programming procedure:
•
Press the
PROGRAM SELECTION (2)
and
DELAYED START (3)
buttons simultaneously for 3
seconds until the
DISPLAY (7)
shows the symbol of the parameter to be modified (see table);
•
Press the
DELAYED START
button
(3)
to modify the parameter;
•
Press the
PROGRAM SELECTION
button
(2)
to change the parameter for modification and/or
to exit from the procedure.
DISPLAY SYMBOL PARAMETER ADJUSTABLE VALUE EFFECT
0
OFF
ACOUSTIC DEVICE
1
ON
0
NORMAL
WATER PRESSURE
1
LOW
3.3 Washing programs
The dishwasher is equipped with a control panel and an
INFORMATION DISPLAY
, described in
chapter "3. Description of the controls", from which it is possible to carry out all the power switch-
on, switch-off and programming operations.
See enclosed program table for washing cycles and the procedure for starting the dishwasher and
switching it on/off.
Before starting a washing program make sure that:
•
The water supply tap is
open.
•
The
correct amount of detergent
has been added to the
dispenser
.
•
The baskets have been
correctly loaded.
•
The spray arms are able to
rotate freely
and without obstruction.
•
The dishwasher door is
securely closed
.
HALF-LOAD FUNCTION (certain models only)
This function is recommended for loads of up to
6 place-settings
, and cuts down on the use of
water and electricity. It can be selected using the
HALF LOAD (6)
button and there are three
different options:
1) pressing the button just once selects the upper basket;
2) pressing the button a second time selects the lower basket;
3) pressing the button a third time reverts to the full load function.
After having selected the desired washing program in the usual manner, choose one of the above
three loading options: on the
INFORMATION DISPLAY (7)
, the indicator light corresponding to the
selected basket will illuminate for 5 seconds, after which the
INFORMATION DISPLAY (7)
will
revert to showing the selected program. In order to check again the currently selected basket,
simply press the
HALF LOAD (6)
button once before starting the program.