Smeg CSE66-I2 Dishwasher User Manual


 
User instructions
32
It is possible to place a cutlery basket inside the basket selected for the
HALF LOAD
program; the
other basket
must
remain empty
.
WARNING: do not load dishes and cutlery into the non-selected basket, because the water
spray will only reach the selected basket.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
Always try to run the dishwasher
fully loaded
.
Do not wash the dishes in running water.
Use the washing program that is
most appropriate
for each type of load.
Do not carry out any preliminary rinsing.
If available, connect the dishwasher to a hot water supply up to 60°C.
When possible,
disable the drying cycle
and leave the door open at the end of the washing
cycle: the residual air and heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
separate
the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
do not pour
the detergent directly on the dishes.
REMOVING THE DISHES
At the end of the washing program, wait at least
20 minutes
before removing the dishes, to allow
them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in
the lower basket, it is
advisable
to unload the lower basket first, and then the upper basket.
SLIDING FACING PANEL (for "fully integrated" models only)
Some dishwashers are equipped with a
FRONT DISPLAY
carrying the same information as the
one on the top control panel.
A system which moves the facing panel allows this display to be revealed when the dishwasher
door is
closed
; to do this follow the instructions in the "
MOVING THE FACING PANEL
" point.
While the program is in progress, the display shows the time left before it ends (hours alternating
with minutes), and the symbols described in section "3. Description of the controls" and any error
warnings
E2
,
E3
,…
E9
also appear.
The
LUMINOUS LOGO
remains off throughout the cycle and illuminates when it ends.
LUMINOUS LOGO FRONT DISPLAY