Filter
Top Products
25
Before connecting the appliance to the power supply, check that the
wires of your electric installation have sufficient diameter to supply
power to the appliance normally. The fuse for the installation should be
10 amps.
It is necessary to provide a bipolar cut-off device in the power supply circuit,
where the opening of the contacts is more than 3 mm.
The electric connection should be done before the appliance is set in the
cabinet.
The drawer should be connected by the (standard) power cord with three 1
mm² couplers (1 single phase + 1 N + ground) to the 220-240 V single phase
power supply via an electric circuit corresponding to the standard CEI 60083
or complying with the installation rules. The protective wire (green/yellow)
corresponds to ground
on the appliance and should be connected to the
ground of the installation.
In the case of a connection via an electric outlet, the outlet should be
accessible after the installation of the appliance.
The neutral on the heating drawer (blue wire) should be connected to neutral
on the power supply.
If the supply lead is damaged, it must be replaced by an equivalent lead
(H05RNF 3x1mm²) available from the after-sales department.
Installation GB