Filter
Top Products
User instructions
34
FAULT DESCRIPTION
E7
Turbine flow-regulator malfunction
The appliance is not able to "measure" the
amount of water loaded accurately. Interrupt
the program and switch off the dishwasher.
Switch the dishwasher back on, program it
again and start the washing cycle. If the
problem persists, contact the after-sales
service.
E8
Alternate washing system malfunction
Interrupt the program and switch off the
dishwasher. Switch the dishwasher back on,
program it again and start the washing cycle. If
the problem persists, contact the after-sales
service.
E9
Water intake system malfunction
Contact the after-sales service.
Light off
Light on
Light flashing
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
• Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program
immediately.
• The E5, E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
• The alarm E7 is visualized at the end of the cycle that comes, however,
brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
• Open and close the door, or turn off and on the machine. At this point is
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.