Filter
Top Products
Instructions for the user
47
13.3.4 Looking after the self-cleaning liners
The liners should not be cleaned with abrasive creams or ordinary detergents. Use a damp sponge
only, so as not to damage the special characteristics of the enamel which coats the liners.
13.3.5 Assembling the self-cleaning liners
1. Remove all accessories from the oven;
2. Remove the side grilles (fig.1);
3. Extract the side liners “F” and “G”(fig. 2);
4. Remove the back panel “A” after undoing the threaded ring-nut “C” (fig. 2).
5. Reassemble the panels, restoring them to their original position.
2)
1)
To remove the self-cleaning liner at the back of the small oven, extract it from the two screws on the
bottom of the oven. To replace it, align the two holes on the liner with the two screws on the bottom
and pull down until engaged.
13.4 Door glass
The door glass should always be kept clean. Use absorbent kitchen paper to clean. In case of tough
spots, clean with a damp sponge using regular detergent. This oven door is air cooled. Care should
be taken not to use excess moisture for cleaning, and avoid spillage through the vents.
MAINTENANCE
The oven may require maintenance or replacement of parts subject to wear such as seals, bulbs, and
so on. The following instructions describe how to carry out these minor maintenance operations.
Before any intervention, disconnect the power supply of the device.
13.5 Replacement of light bulb
Remove the bulb protector A by turning anticlockwise and change bulb B with a similar one. Re-fit the
bulb protector A.
Only use oven bulbs (T 300°C).