Filter
Top Products
Instructions for the Installer
8
4. MAKE ELECTRICAL CONNECTION
WARNING
ELECTRIC SHOCK HAZARD
- Disconnect power to the junction box before making connection
- Electrically ground the appliance with green or green-yellow colored
wire
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DEATH,
FIRE OR SHOCK.
This appliance is manufactured with a yellow and green or green ground wire connected to the oven
chassis.
To prepare connection between the oven and the junction box:
- Disconnect power supply to the junction box,
- Feed the flexible cable conduit from the oven through the opening of the cabinet,
- Remove junction box cover if it is present,
- Install UL listed and CSA approved conduit connector to the junction box,
- Route the flexible cable conduit from the oven to the junction box through a UL listed or CSA
approved conduit connector.
- Tighten screws on conduit connector,
- Refer to figures 1 and 2 below, which represent the most common way of making electrical
connection.
IMPORTANT: Your eventual local codes and ordinances must be followed first to the instructions.
NOTE: Frame grounded by connection of grounding wire to neutral wire. If used in new branch circuit
installation (1996 NEC) or if local codes do not permit grounding through neutral wire, open the
connection and use grounding wire to ground unit in accordance with local codes. Connect neutral wire
to the branch circuit’s neutral conductor in the usual manner:
- Disconnect the ground from the neutral at free end of conduit,
- Use grounding terminal or lead to ground unit, and
- Connect neutral terminal or wire to branch circuit neutral in usual manner (see pic. 2 below)