Filter
Top Products
14
EN
1
4
13
Charcoal filter (ductless version)
This filter cannot be washed or regenerated. It has to be replaced when the EF appears on the
display or at least once every 4 months.
Activation of the alarm signal
• In the recycling version hoods the filter saturation alarm has to be activated during the in-
stallation or later.
• Switch off the hood and the lights.
• Press the E-key for about 5 seconds until the LED on the display start to move.
• Press the B-key within 5 seconds until a confirmation of the activated state of filter satura-
tion alarm on the display appears:
• 2 flashings on EF - charcoal filter saturation alarm ACTIVATED
• 1 flashing on EF - charcoal filter saturation alarm DEACTIVATED.
SUBSTITUTION OF THE CHARCOAL FILTER
Alarm reset
• Switch off the motor and the lighting system.
• Press the G-key for at least 2 seconds.
Substitution of the filter
• Remove the metal grease filters.
• Remove the charcoal filter as indicated in the picture.
• Place the filter again into its seat.
• Place again the metal grease filters into their place.
Lighting
LIGHT REPLACEMENT
20 W halogen light.
• Remove the 2 screws fixing the Lighting support, and pull it
out of from the Hood.
• Extract the lamp from the Support.
• Replace with another of the same type, making sure that the
two pins are properly inserted in the lamp holder socket holes.
• Replace the Support, fixing it in place with the two screws re-
moved as above.