Filter
Top Products
User instructions
15
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“I
NTERRUPTION OF A PROGRAM”).
Now press buttons P1+P2 simultaneously and
the first three program lights will come on.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “START PROGRAM”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.
HALF LOAD WASH FUNCTION (on some models only)
(available in all programs except the soak program)
Pressing button ½ LOAD WASH (4) selects washing on the top basket
only.
After selecting the program, proceed as follows:
• press the button ½ LOAD WASH (4) once to select the top basket
(the relative light comes on);
• press the button ½ LOAD WASH (4) again to return to full load
wash status (the light goes out).
N.B.: selecting the ½ LOAD option changes the duration of the program.
A cutlery basket can be placed in the upper basket, while the lower
basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the
lower basket, since the jet of water will only reach the upper basket.