Filter
Top Products
Instructions for the installer
2.2 Attachment to support structure, flush-mounting model
Create an opening with the dimensions
shown in the figure in the work surface,
observing a minimum distance of 50 mm
from the rear edge.
1)
The lower part of the protective cover
must be fully accessible when the
appliance is installed. This appliance can
be installed next to walls that are higher
than the work surface, as long as the
distance "X" is kept, as shown in the
figure, to avoid damage from overheating.
Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf
that may be installed directly above them. This type of appliance also requires a cut 3
mm deep in the work-top with the dimensions shown in figure 4 (detail A, figure 2).
Before positioning the hob, position the adhesive sponge material “E” supplied over
the milled surface (fig. 2). Now place the hob on the cut in the work-top and use the
screws and fixing brackets (sequence shown in Fig. 3) to secure the hob to the
supporting structure, adjusting it until perfectly horizontal. Do not fit the brackets
shown in fig. 3 until the hob has been set in place.
2)
3)
4)
Mill to this depth for laminated worktops of less
than 3mm thickness.
Apply a layer of “waterproof primer” to the milled surface.
23